creatornax.blogg.se - Firmware tanaka champion version 2

- could not be selected for Custom Setting f4 in modes M and A when an F mount lens was attached.

- With certain Z mount lenses, choosing for Custom Setting a1 with selected for would sometimes disable the shutter release even when the subject was in focus.

You can now expect better results from vibration reduction during panning shots taken with the camera pointing up or down and an option other than selected for.

Fixed an issue that resulted in the camera focusing on the background when, , or was selected for, or when or was selected with a custom focus-area size of.

Autofocus now produces more accurate results with human portrait subjects detected via eye/face-detection AF with selected for.

Autofocus is now better at tracking small subjects.

For more information, see the Supplementary Firmware Update Manual.

has been added to the roles that can be assigned to camera controls using Custom Setting f2.

Fixed an issue that in very rare circumstances would cause the camera to stop responding.Ĭhanges from Previous Versions Changes from “C” Firmware Version 2.00 to 2.10.

Do not turn off the camera until the firmware update is complete.Ĭhanges from “C” Firmware Version 2.10 to 2.11 A progress bar will be displayed when the update begins, but when updating from a “C” firmware version earlier than 2.00 you may notice that it takes about 2 minutes for the progress bar to be displayed. This update takes approximately 6 minutes. Read the information below before proceeding.This update includes all changes made in previous updates.You will not need to download this update if the firmware listed above is already installed. Use Firmware version in the SETUP MENU to check the camera firmware version before proceeding. This service supplies software that can be used to update the Z 9 camera “C” firmware to version 2.11.

Be sure you understand the terms of the agreement before beginning download. By selecting “Accept” and clicking “Download”, you are held to have accepted the terms and conditions of the agreement. This software update program is for the customer-owned product listed above (the “affected product”), and is provided only on acceptance of the agreement listed below.